龙珠激斗首抽超赛孙悟空:低壓成套開關設備 GGD

10-.jpg

龙珠激斗2.3无敌版 www.fvmfo.icu 產品簡介
Brief introduction to the products

GGD型交流低壓配電柜適用于發電廠、變電站、廠礦企業等電力用戶的交流50Hz,額定工作電壓380V,額定工作電流至3150A的配電系統,做為動力、照明及配電設備的電能轉換、分配與控制之用。

The GGD AC Low-Voltage Distribution Cabinet is suitable for power plants, substations, factories and mines, AC 50Hz, rated working voltage 380V, rated woeking current up to 3150A, as power, lighting and the power conversion and control of the power distribution equipment.

結構特點及功能
Structural Characteristics and Functions

★柜體采用通用柜的形式,構架用8MF冷彎型鋼局部焊接組裝而成,構架零件及專用配套零件由型鋼定點生產廠配套供貨,以保證柜體的精度和質量;

★在柜體上下兩端均有不同數量的散熱槽孔,當柜內電器元件發熱后,熱量上升,通過上端槽孔排出,而冷風不斷地由下端槽孔補充進柜,使密封的柜體自下而且上形成一個自然通風道,達到散熱的目的;

★柜門用轉軸式活動鉸鏈與構架相連,安裝、拆卸方便。門的折邊處均嵌有一根山型橡塑條,開門時門與構架之間的嵌條有一定的壓縮行程,能防止門與柜體直接碰撞,也提高了門的防護等級。

★柜體的頂蓋在需要時可拆除, 便于現場所主母線的裝配和調整,柜頂的四角裝有吊環,用于起吊和裝運。


The cabinet is of common form. The framework is composed of 8MF cold bending profile steel welded and assembled. The frame parts and the special necessary parts are provided by the specially appointed manufacturers so as to ensure the precision and quality of the cabinet;

At the upper and lower ends of the cabinet there are different numbers of cooling slots. When the electrical components inside of the cabinet are scattering heat,  the heat in the cabinet is increased and discharged through the top cooling slots while the cooling air is entering constantly the cabinet through the bottom cooling slots, forming from bottom to top a natural ventilation duct to scatter the heat;

The door of the cabinet is connected with the axis hinge to the framework and the disassembling is rather convenient. A rubber insertion strip is fixed at the edge of the door for avoiding direct collision of the door with the cabinet, increasing the protection level of the door.

The cap of the cabinet can be removed, if necessary, for the convenience of assembling and adjustments of the main buses. The lifting rings are fixed at four corners of the top of the cabinet for lifting snd transportation.


技術參數
Product Structure

未標題-20.jpg


外形及安裝尺寸
Type and Dimensions

未標題-21.jpg

未標題-22.jpg

使用條件
Conditions of Use

※ 周圍空氣溫度不高于+40℃,不低于-5℃。24小時內的平均溫度不高于+35℃。

※ 戶內安裝使用,使用地點的海拔高度不得超過2000M。

※ 周圍空氣相對濕度在最高溫度為+40℃時不超過50%,在較低溫度時允許有較大的相對濕度。(例如+20℃時為90%)應考慮到由于溫度的變化可能會偶然產生凝露的影響;

※ 設備安裝時與垂直面的傾斜面度不超過5度;

※ 設備應安裝在無劇烈震動和沖擊的地方,以及不足使電器元件受到腐敗蝕的場所。


Ambient Temperature ≥-5℃ ≤+40℃; Average temperature within 24 hours ≤ +35℃.

Indoors. Height above Sea Level ≤ 2000 M.

Relative Humidity: ≤ 50% at +40℃ (Max); At a lower temperature to allow a greater relative humidity (for example 90% at +20 ℃). It should be considered that due to the temperature variation, the jel phenomenon may be effected.

For installation, the tilt of the vertical surface does not exceed 5°

The installation site should be free from violent vibration, impact and corrosion of the electrical components.